'** This is the config file for (your prog name) prog **
'
' The rules are:
'       All non-data line need a comment at the start.
'       Blank lines are OK but are bad practice.
'       Data identifiers are in the form DATA=this_is_data.
'       Well, I suggest CAPS for the identifiers...you code whatever...
'       Data order is not important.
'       Comments after data are retained, indented and ignored.
'       Avoid formatting chars e.g.Tabs.
'       Data stored as strings, spaces allowed.
'
COMM=1                                  'comm port number
QHOURS=18.64                            'quartz lamp hours
QNUMBER=024                             'quartz serial number
HGHOURS=.15                             'Mercury lamp hours
HGNUMBER=999                            'Mercury lamp serial number
QDATE=25-05-12                          'cal date for quartz lamp dd-MM-yy
PSUNUMBER=8034                          'powersupply serial number
PSUDATE=05-08-04                        'cal date for PSU dd-MM-yy
RESNUMBER=8136                          'resistor serial number
RESDATE=31-05-05                        'cal date for resistor dd-MM-yy
CLUNUMBER=V024                          'Calibration Lamp Unit sn#
LOGFILENAME=uv3V024log.txt              'name for log file
TempSens=therm                          'determines what temp (lm35)
SMTP_Host=SMTP                          'name of SMTP host
InstrumentAddress=UV3@mlo.noaa.gov      'name of instrument (eMail address, needs an @ in it)
DestinationAddress=m.kotkamp@niwa.co.nz 'eMailaddress of destination
BoxTemp=20                              'desired Box/room temperature
ExtraTemps=extra                        'display extra chans (extra or no)
MailSlotChar=.                          'either * (everybody on domain)or . (just on PC) for Mailslot domain level
MailEnable=No                           'enable emails, Yes or No
AgilentNumber=6023                      'Use last 4 digits of Agilent serial   'comment for variable 21
'