'** This is the config file for (your prog name) prog **
'
' The rules are:
'       All non-data line need a comment at the start.
'       Blank lines are OK but are bad practice.
'       Data identifiers are in the form DATA=this_is_data.
'       Well, I suggest CAPS for the identifiers...you code whatever...
'       Data order is not important.
'       Comments after data are retained, indented and ignored.
'       Avoid formatting chars e.g.Tabs.
'       Data stored as strings, spaces allowed.
'
COMM=1                                  'comm port number
QHOURS= 316.52                          'quartz lamp hours
QNUMBER=14                              'quartz serial number
HGHOURS= 104.55                         'Mercury lamp hours
HGNUMBER=13                             'Mercury lamp serial number
QDATE=30-03-05                          'cal date for quartz lamp
PSUNUMBER=9                             'powersupply serial number
PSUDATE=30-06-05                        'cal date for PSU
RESNUMBER=9                             'resistor serial number
RESDATE=26-09-05                        'cal date for resistor
CLUNUMBER=13                            'Calibration Lamp Unit sn#
LOGFILENAME=UV5clu13log.txt             'name for log file
TempSens=lm35                           'determines what temp (lm35)
SMTP_Host=SMTP                          'name of SMTP host
InstrumentAddress=UV5_Bld@niwa.co.nz    'name of instrument (eMail address, needs an @ in it)
DestinationAddress=m.kotkamp@niwa.co.nz 'eMailaddress of destination
BoxTemp=30                              'desired Box temperature
ExtraTemps=extra                        'display extra chans (extra or no)
MailSlotChar=.                          'either * (everybody on domain)or . (just on PC) for Mailslot domain level
MailEnable=No                           'enable emails, Yes or No
AgilentNumber=4715                      'Use last 4 digits of Agilent serial   'comment for variable 21
'