data.process.ingest.raw_clap3w

data.process.ingest.raw_clap3w takes raw data generated by the CLAP-3W and creates CPD2 style “a”, “m” and “n” records from it. Creates “a” records every minute, “m” records every 15 minutes, and “n” records after a spot change.

Command Line Usage

data.process.ingest.raw_clap3w [--input=CPD2|starttime|linetime] 
                               [--output=A11] [--station=NIL] [--change-on-reset]
                               [--stablity-min=30] [--stablity-max=60] [--stablity-rsd=0.0005]
                               [--spots=1.7814E-5,...1.7814E-5] [--force-spot=N]
                               [--a=1,...] [--b=0,...]
                               [--interval-a=60] [--interval-b=900]
                               [file|-]

Arguments

--input=CPD2

Select the input data format.

CPD2 - CPD2 Style raw data logger output.
starttime - A single start timestamp (currently only P3 format, “5/10/2010 6:34:58 PM” is supported).
linetime - A timestamp as the first field of every time. Any convertable time format is accepted.

--output=A11

Instrument to output for, defaulting to A11.

--station=NIL

Set the station to output records as, defaulting to NIL.

--change-on-reset

Trigger a filter change whenever the uptime decreases (CLAP reset) instead of just when the filter and/or spot ID changes.

--stablity-min

Minimum number of points required for spot stability.

--stablity-max

Maximum number of points for spot stability.

--stablity-rsd

Minimum RSD for spot stability.

--spots=1.7814E-5,...1.7814E-5

List of spot sizes in m^2.

--force-spot=N

Force the spot to always be a given number, ignoring the instrument reported value.

--a=1,... --b=0,...

List of digital filter coefficients, starting at a0 and b1 for each parameter. The filter is disabled during spot normalization and reset after it.

--interval-a

Set the interval between “a” records in seconds. Defaults to 60. Zero disables.

--interval-m

Set the interval between “m” records in seconds. Defaults to 900. Zero disables.

file|-

Filename to read, or “-” for standard input. Defaults to standard input.

Example Usage

data.get sfb XA13r 2010-04-19 2010-04-20 | data.process.ingest.raw_clap3w

Information

Data